Al - 22.6 at.% Zn - 0.1 at.% Mg Alloy

Alloy name: Al - 22.6 at.% Zn - 0.1 at.% Mg
Diagram No.: 5
Type of diagram: TTP
Chemical composition in atomic %: 22.6 at.% Zn, 0.1 at.% Mg, balance is Al
Alloy group: Aluminum-based alloys
Note: Hot rolled to a thickness of 0.317 cm and then cold rolled to a final thickness of 0.0081 cm. Polycrystalline specimens 1.02 x 12.7 cm were cut from the center of the cold rolled material, homogenised within 3 deg. at 400 C (762 F) for 1 h, and quenched into an ice bath directly below the furnace. All isothermal heat treatments were made at 76, 100, 125, 160, and 175C (184, 212, 257, 392, and 347 P) in a silicone oil bath controlled to within 1 deg.
Reference: Not shown in this demo version.

Transformation Diagram

Price: 30.00 US $
Buy Online Transformation Diagram

Other Steel Data links
Carbides in Steel
Etchants Database
Hardenability Diagrams of Steels
Macro Defects in Steel
Non-Metallic Inclusions in Steel
Tempering Diagrams of Steels
CCT and TTT Diagram Calculating Service
Transformation Diagrams of Non-Ferrous Alloys

Disclaimer: The information and data presented herein are typical or average values and are not a guarantee of maximum or minimum values. Applications specifically suggested for material described herein are made solely for the purpose of illustration to enable the reader to make his own evaluation and are not intended as warranties, either express or implied, of fitness for these or other puposes. There is no representation that the recipient of this literature will receive updated editions as the become available.






Copyright © 2019 by Steel Data. All Rights Reserved.